Free tips & tricks how to clean up a computer for speed up your registry PC

You are using your computer for a long time. Now its need to clean up . So  you are thinking t... thumbnail 1 summary
You are using your computer for a long time. Now its need to clean up . So  you are thinking to do this but you are not doing that. Its time to starting. Today I have written an article about  clean up your PC. I hope it will be helpful for you.

Step 1.Gather the tool you need. You need compressed air and a screwdriver to open the computer case. A small vacuum might clean up the mess you make around the computer , but should never be  used inside it. A dusk musk is suggested because it can save you a bit of sneezing if you need to clean a computer quickly.

Step 2.Shut down and unplug your computer.

Step 3.disconnected LAN cable all peripherals, such as monitors, scanners, printers, keyboards, mouse and speakers.

Step 4.Move to a suitable area. IF you haven’t cleaned your computer in a while ,at first you need a suitable work area.While you can clean your computer where it sits, it is not commended .The job can be very easy and you will want to work somewhere where you can adequately ventilate dust.

Step 5. Open your computer. Once you have a suitable place ,now you  can open your computer .This will greatly depending on your PC’s casing .If you have a user’s manual, consulting it would be a good idea .Most  machine have screws holding a side panel down. After removing  these, you can them slip the side off your machine.

Step 6.Prepare to clean. After opening the computer, use compressed air. Additionally , you might want to wear a dusk musk. Never touch the inside of PC unless it is absolutely necessary. You may discharge a static shock to vital internet components (such as CPU and RAM) and damage them. If you must touch the inside of your machine , discharge any static by tapping your finger to the computer’s metal case before unplugging it.

Step 7.Begin dusting . Use your compressed  air to blow out the inside of your machine. It is normally a good idea to start on the upper region of the computer, then work your way down. It this manner you can sweep out all the dust that settles on lower components in one run. Don’t worry if cause the blades of internal fans to spin. This is important to keep these clean. Be through, but do not press on cords. Also keep your air source a moderate distance from the component you are working on 

      A lot of dust can be raised; try not to breathe it . If the PC very dusty, take it out of doors before using the compressed air.
·     Compressed air is freezing cold when it leaves the can; don’t let frost on your chips.

Step 8. Make sure heat sink fan is clean. The heat sink sits over the processor, and it is a collection of metal ridges that stick up away from the motherboard .If the fan does not work properly, the processor will overheat and it can damage your PC.

Step 9. Look around the inside & outside dust that you may have missed. Once you are sure it is cleaned thoroughly, carefully replace the sides. Do not try to force them into place.

Step 10. Clean up your work space. The initial run will churn up a lot of particulates. Depending on your workplace, you may need to get a small vacuum and clean the area around the computer. Do not use a vacuum on the inside of the computer. 

Step 11. Close your PC. After you have finished dusting, replace the side of your machine and any screw. Once the caching is tightly shut, return it to its usual spot and attach the power cord and other cables. If you flipped the master power switch on the back of your machine off, be sure to turn it on again or your machine will not start. A clean computer work significantly cooler.

No comments

Post a Comment